Slide Produces Mold Care Products Used In The Plastics Injection Molding Process. Mold Cleaners And Degreasers, Mold Release Agents, Rust Preventives For Protecting Molds As Well As Purging Compounds To Clean Out Injection Barrels.
Formerly Percy Harms Corporation founded in 1953 is well known and respected within the plastics industry for it's formulation products of mold release agents, mold cleaners, rust preventives, purging compounds, and lubricants. Seventy percent (70%) of Slide Products are primarily used in the plastic injection molding industry and the balance of their products are used in extrusion molding, blow molding, film & sheet molding including vacuum forming/thermoforming and potting/encapsulating.
Contains No Ozone Depleting Chemicals
Non-Chlorinated
No Methylene Chloride
No ChloroFluorocarbons (CFC's)
Cleans molds at room temperature without wiping
Paintable mold release
Fast-drying on cold and hot molds
No chlorinated solvents
Maximum operating temp: 482°F/250°C
Approved for indirect food contact (†)
† 21CFR 178.3570
Paintable, non-silicone mold release
Food-grade active ingredient (††††)
Fast-drying on cold and hot molds
No chlorinated solvents
Maximum operating temp: 500°F/260°C
†††† 21CFR 184.1400 (GRAS)
Paintable
Permits post-decorating of molded parts without prior cleaning
No chlorinated solvents
Maximum operating temp: 482°F/250°C
Approved for indirect food contact (†)
† 21CFR 178.3570
Paintable release, will not interfere with post-molding decorating of parts
Specifically developed as a release for polycarbonate resin
Recognized by UL
Solvent-free dry formulation
Maximum operating temp: 650°F/343°C
Non-silicone, paintable mold release
Food-grade active ingredient (†††)
Recognized by UL
Solvent-free dry formulation
Contains no lecithin
Safe to use on most thermoplastics
Use where parts must be painted, hot-stamped or metalized
Maximum operating temp: 600°F/315°C
††† 21CFR 172.878 and 178.3620 (a)
Formulated for deep draw molds
Excellent for most rubber & thermoplastics including ABS, polycarbonate, nylon and vinyl
No chlorinated solvents
Use it on phenolic & urethane resins
Contains PTFE
Maximum operating temp: 500°F/260°C
Bulk versions of this product should be thoroughly stirred prior to use
Paintable, non-silicone release contains boron nitride
Effective release for engineering grade resins, low melting point metals and glass
Recommended for use with Ultem and other engineering-grade resins
High temperature mold release agent
No chlorinated solvents
Maximum operating temp: 1800°F/982°C
No chlorinated solvents
Neutralizes corrosive vapors and prevents resin deposit build-up
Helps protect against corrosive hydrochloric acids from PVC resin and flame-retardant additives
Paintable, non-silicone release
Maximum operating temp: 550°F/287°C
